|
LM12 Lamp module
This plug-in module is a 300 Watt receiver
unit that works as a remote dimmer.The connected lamp
can still be switched on and off locally. The dimmer
module can be used at any wall outlet in the house with
incandescent lamps between 40 W and 300 W.
|
 |
|
AM12 Appliance module
The AM 12 plug-in module is a 500 Watt receiver
unit that works as a remote controlled switch/relay.
It receives X-10 signals and responds by switching On/Off,
the appliance (load) connected to it. The connected
load, for example (washing machine) can also be switched
on and off locally. The switch can be used at any wall
outlet in the house.
|
 |
|
LW10 Wall mounted dimmer switch
The LW10 Wall mounted dimmer is a direct
replacement for a standard light switch. It will control
up to 300Watts of incandescent lamps. Can be remotely
controlled using X-10 commands "On/Off , All Lights
On/All lights Off, Dim/Bright". Used in conjunction
with the 8-in-1 remote and TM12 transceiver.
|
|
|
AW10 Wall mounted switch
The AW10 wall mounted switch can be used
to control lights, fans, appliances fluorescent lighting,
etc rated up to max 10 Amps.
Can be remotely controlled using X-10 commands "On/Off
, All Units On/All Units Off". Used in conjunction
with the 8-in-1 remote and TM12 transceiver. This
switch requires a neutral wire.
|
|
| The following products
should only be installed by a qualified electrician |
AD10
Din Rail mounted switch
The AD10 is a remote controlled relay and is
normally mounted in the fuseboard. Can be remotely controlled
using X-10 commands "On/Off , All Units On/All Units
Off" and can also be controlled by standard electrical
switches (latched or momentary action). Rated at 16 Amps. |
 |
LD10
Din Rail mounted Dimmer switch
The LD10 is a remote controlled dimmer and
is normally mounted in the fuseboard. Can be remotely
controlled using X-10 commands "On/Off , All Lights
On/All Lights Off, Dim/Bright" and can also be controlled
by electrical switches ( momentary action). Rated at 700
Watts.It also has a memory feature where it remembers
its dim level. |
 |
FD10
Din Rail Mounted Filter/Coupler
The FD10 is mounted in the fuseboard and is
used to stop the X-10 signals from leaving or coming into
the house electrical wiring system. It can also be used
to allow X-10 signals to work over a 3 Phase electrical
system. |
 |